line sensor

We are steadily preparing line sensors.

This is actually a return match from about 2 years ago.
I had too little knowledge and experience back then. And hardware environment.

Now we know what to do. Including its logic.

First of all, it was a free run, but we were easily able to capture a clean image of the board.
Now we just need to make sure the encoder is well synchronized and adjusted, and we should be able to get a good level.

The first target is,
"about 7400 pixels x 12000 lines, pixel resolution 24μm = 177mm x 288mm"
The first target will be "7400 pixels x 12000 lines".
It will take about 1 second to capture an image and inspect it within 2~3 seconds after capture.
The inspection method is the usual FlexInspector method.

We are hoping to manage to get images by the end of the year.
We will keep you posted on our progress.