Ping-pong method About multi-sided inspection
The standard specification for the ping-pong method is a one-sided inspection.
Multifaceted inspections are not supported.
Still, there is a need to inspect multiple surfaces.
Possible operational methods in this case are
KEEP INSPECTING ONLY SIDE A,
Then switch varieties.
CONTINUE TO INSPECT ONLY SIDE B.
This is a possible way to do this.
OF COURSE, IF YOU CONNECT A PLC FOR EXTERNAL CONTROL,
There are many more possible ways to do this.
But if you are trying to keep it low cost,
I think the above would be best.