What is important in quality inspection

Here is a part.
Compared to other parts, the part is obviously bent.
However, the amount of deformation is within the range of good products according to the standard value.

What would you think if you received those parts?

What is a standard value? What is a good range?

After all, it is important that "everything is finished without variation,
Even if we discuss whether a mere few measurements are included in the standard values, which are based on ambiguous grounds....
And even if we discuss whether the accuracy of the measured values is high or low....

The scary thing about FlexInspector is that it changes the way we think about things....