On the occasion of the International Technical Exhibition on Image Technology and Equipment '08

The '08 International Technical Exhibition on Image Technology and Equipment is finally starting.
To be honest, we are still busy with preparations.
As usual...
This time, the person who was in charge of XY stage control, etc.
The person who was in charge of XY stage control passed away suddenly at the beginning of this month, so I am feeling quite overwhelmed.
PLC, touch panel... It was the first time for me to use it, but I could make it work.
I will say that some of the poor workmanship was a blessing in disguise.
The exhibits at this year's show were interesting.
In a sense, we may have invested all the technology we have.
The line-sensor type visual inspection system shows a much better image than you can imagine.
FlexInspector's detection capabilities work effectively on those images.
For an M-size board, it takes only a few minutes to set up,
"For an M-size board, it takes only a few minutes to set up, and within 7 seconds from the start of image capture, the board inspection system shows the defective area on the screen.
The XY stage is equipped with a continuous_detection_stage.
The XY stage is equipped with a special imaging method called continuous_grabbing, which is unique to PC image processing, and a stroboscope.
The XY stage uses a special imaging method called continuous_grabbing, which is unique to PC image processing, and strobe illumination,
The XY stage is equipped with a special imaging method called continuous_grabbing, which is unique to PC image processing, and stroboscopic illumination.
It is difficult to reduce the time to less than 300ms per piece with normal pitch feed,
However, the system achieves a throughput of about 200 ms per piece (2.54 mm pitch).
While the maximum speed of the stage used is 16 mm/sec,
2.54/0.2 = 12.7mm/sec, you can see how highly efficient it is.
In the end, we would like to create a database of inspection results with FlexInspector, but unfortunately, we can't do that until now.
But unfortunately, we have not reached that point this time.
But I still feel like I'm running out of time...
We hope you will be able to experience the possibilities of FlexInspector.
Please stop by our booth #33.